Notice:
when the parcel arrived to your customs, please pay the tax and pick up
the parcel,we are not responsible for any customs duty or import tax.
If your place is remote, then need to pay 45usd .
Specifications:
Name: GSR40 Gas Nail Gun
Charger voltage: 110-220V
Working voltage: 7. 2V
Number of Nails: 30
Gas consumption: 1000-1200 times/can
Working rate: 120 times/minute
Scope of application: fixed door and window frames, billboards, brackets, trunking, air conditioning ducts, iron sheets, etc.
Note:
The product does not contain gas.
Charger instructions:
When the battery is plugged in and charged, the red light is always on,
and the green light is displayed when it is fully charged.
If the battery is reversely inserted and charged, it will cause the charger to
burn out, so pay attention to the positive and negative poles of the battery.
Indicator Light:
1. Steady green light: indicates normal operation
2. Green light flashes: indicates that it is in standby
3. Steady red light: indicates insufficient battery
4. Red light flashes: it means you need to take a break after overheating
5. The red and green lights flash alternately: it means it is close to the
thermal protection temperature
6. The yellow light is always on: it means it needs cleaning
Common Problems:
1. The striker does not reset
Reason analysis: long-term non-cleaning will cause the air tank
to be unsealed. Normally, it will be cleaned every 2000-5000 nails.
Solution: Need to clean the cylinder head, cylinder, lubricate oil,
and adjust the opening direction of the piston ring to 180°.
2. The fan rotates, but the gas gun does not sound
Solution: Check the quality of the air intake nozzle; gas cylinder and the ignition coil, etc.
3. The nail cannot be completely driven in
Reason analysis: wear of piston rod
Solution: Replace the piston rod
Reasons and solutions for the nail gun not working properly:
1. The nail gun has a safety device, which cannot be driven when there are only a few nails;
2. Check the gas, refer to the video to test the gas
3. After eliminating the previous problem, you can try to remove the 4 screws of the cover,
then turn the cover up, then press the trigger, check whether the fan is running and whether
the ignition is normal, the ignition position needs to be kept clean and free of foreign
objects, then If the rubber ring is dry, apply some lubricant to it. For details, please refer to
the video below.
Picture showing: