1. Product Size: Size A: 60 cm * 150 cm / 23.62 inch * 59.06 inch Size B: 60 cm * 180 cm / 23.62 inch * 70.87 inch Size C: 50 cm * 125 cm / 19.68 inch * 49.21 inch
Installation Introduction:
1. Prepare with water(better to add some detergent), hard card, knife, dry cloth
2. Clean the fridge surface with water and detergent.
3. Peel off the protect film and paste it onto the fridge
4. Scrape extra water and remaining air bubbles with a the card from the pattern middle to around.
5. Trim around the edge.
6. Rub away the water on the sticker with the dry cloth.
Attention:
1. This Item is a DIY Product, It should be put by yourself.
2. Can be attached to any smooth surface such as:walls,tile,all kinds of wooden furniture,refrigerators refurbished stickers,appliances and furniture
3. Please allow 1-3mm error due to manual measurement.
4. The colors may have different as the difference display, pls understand.
5. Please make sure that you have clean the grease and stains on the surface with dry cloth before sticking the wall decal. It can make the wall decal be attached on the surface more firmly.
6.You can tear the protect paper then apply it to the corresponding area. Because of its special material and characterists, there may be some kink marks after packing, but it is not effect its using, what you need to do is using a card To squeeze the bubble and make it flat.
Note:
a)Customized service: We can provide customized size service, if you need other sizes, please contact our service provider to order. b) The size of a customized door sticker does not exceed 120cm
Material and Details
Hope to understand: 1. All products are measured manually, please understand that the tolerance of 1-3cm is allowed 2. Due to the difference of the screen magnification and the shooting light, some chromatic aberration may not be avoided. Please refer to the actual product color.
Suitalble Surface
1. Smooth painting wall 2. Smooth wooden surface 3. Smooth metal surface 4. Smooth ceramic tile surface, ect Tip: please clean the position you want to stick, and paste the sticker on it. Just peel and stick, if you make mistake, you can peel it off and stick again. Hot air from drier will help you remove it from the wall easier. If you have any questio during install, please contact with us for help.